DURAL inclined wedge glass carrier 98 cm

• Height 1 = Maximum pavement thickness
• Height 2 = Total front height
• Height 3 = Total rear height
• Side selection facing the gutter

Our DURAL inclined wedge to glass carrier made of finely ground stainless steel 98 cm long is perfect for installing your floor-level shower. Not only do the profiles form a 2% slope, which is critical for proper drainage, they can also safely accommodate glass panels up to 12 mm thick to contain splashing water. The sloped wedges also cover the side walls of floor-level showers with the brushed surface; we offer extra variants here for the left and right sides respectively. The one-piece inclined wedge is made of only one element in stainless stainless steel (V2A) and enables a visually appealing transition to the floor covering. The finely ground surface creates a uniform as well as high-quality look and is also easy to clean. The leg is also designed so that flexible adjustment to deviations is also possible. 

You can find further gradient wedges without glass carrier from DURAL made of high-quality V2A stainless steel in the lengths 98 cm, 120 cm, 148 cm and 200 cm as well as in the usual heights (10 mm, 11 mm, and 12.5 mm) in our store.

Our tip from alleszumfliesen.de: Order your profiles 1-2 mm higher than the flooring you want to lay.

As a compound sealant, we recommend our ETAG-approved DURABASE ET-S composite waterproofing system, here you will find all the necessary components!

PROCESSING

To shorten the profile, always cut the inclined wedge at the highest point.

To shorten the profile, always cut the inclined wedge at the highest point. Important: There should be no contact between the stainless steel and the glass. Please close the joint between the profile holder and the glass with sanitary silicone or suitable rubber seals / rubber inserts so that the glass does not rest on the blank stainless steel.

Cleaning proof

stainless steel never clean with abrasive media such as steel wool, as this can damage the surface, which can lead to the formation of flash rust. Cleaning agents used must be free of chlorine and hydrochloric acid.