Curver with crank

• High quality, reliable tool
• For precise bending work
• Inexpensive shipping of small parts

A cuver makes bending flexible tile profiles much easier and bends them exactly to the desired radius. The curver with crank is suitable for all tile profiles for bending, as well as for bending selected skirting strips (unfortunately this is not possible with the skirting strips with cable channel ) and transition profiles in T-shape. If you are not sure just call or email us and we will check the item for bendability.
The curver is composed of the following parts: 1. protective cover, 2. bending disc, 3. adjustable by a set screw, 4. a sliding guide roller, 5. two holding rollers, 6. two flat holders and 7. a spacer disc.

Detailed instructions and the composition of the tool can be found below in the attached files.

Instruction manual:

1. The curver is fixed immovably to the worktop or similar with the enclosed screw clamps.
2. The bending plate is moved away from the holding rollers with the set screw using a ratchet. Then push in the profile so that it rests against the two retaining rollers. Then move the bending disc back towards the profile until a slight clamping effect is achieved.
3. To prevent the profile from twisting and damaging the bending roll, the profile must be fixed with the flat holders.
4. By turning the bending roll using the ratchet, the profile is transported further and initially a flat radius is bent.
5. For a tighter radius, the profile must be turned several times. To do this, the guide roller is loosened with the wrench and pushed a little further forward. Then the set screw is used again to move the bending plate and thus also the profile to the guide roller until a slight clamping effect is achieved.
6. After several turns and simultaneous guiding of the profile, the desired radius is created.