Curver for bending tile profile

• High quality, reliable tool
• For precise bending work
• Cheap small parts shipping

A Curver is a bending tool to make your work with flexible (bendable) tile profiles easier. The Curver without crank is suitable for the exact processing of all tile profiles for bending. The scope of delivery of this Curver includes the following components: 1. a protective cover, 2. the corresponding bending disc, 3. this is adjustable by means of the rotary knob, 4. a sliding guide roller, 5. two holding rollers, 6. and two additional flat holders. Drawings of all components can be found in the operating instructions.

Detailed instructions as well as the construction of the tool can be found in the attached appendices.

Instruction Manual:

1. The curver is fixed to the worktop or similar with the enclosed screw clamps.
2. The bending disc is moved away from the holding rollers with the rotary knob. The profile is then inserted so that the profile rests against both holding rollers. (The first 15 cm are bent manually or removed). Then loosen the guide roller with the enclosed wrench.
3. The profile is pre-bent to the desired radius by moving the bending disc using the turning knob.
4. Now the guide roller is pressed up to the profile and tightened in this position. Then the bending disc and thus also the profile are moved up to the guide roller again by means of the rotary knob until a slight clamping effect is achieved. To prevent the profile from twisting and damaging the bending roll, the profile must be fixed with the flat holders.
5. By turning the bending roll and simultaneously guiding the profile, a constant radius is now obtained.
6. If the profile is to be bent with the punching on the outside, the two flat holders must be repositioned. Guide roller and holder rollers must have the beveled side up.